help page

How to troubleshoot Designjet 08:11 error, 08:04 error October 07 2019, 0 Comments

Designjet Printer Sale

Designjetpartsfast.com now offers new Designjet printers, ink, and cartridges for immediately delivery. Models include T630, T650, T730, T830, T1600, T1700, T2600.


Watch this video to troubleshoot error:


Warning . . . HP has written the latest version of firmware that marries new boards to the printer. If you install a new board, the board is married to your printer.  Used boards cannot be returned for a refund. I only sell new parts. 

---------------------------------------------------------

Here is a link I have for the previous rev. of firmware for download:

 

Save the older firmware file to a USB stick and try to boot off of it. Afterwards, remove the USB stick. It may take 3-5 boots to load.

 

---------------------------------------------------------------------------------

 08:04, 08:11 error sub code guide.

 

The formatter board has either a network cable or USB cable plugged into it. Next to the connector there are 3 LEDS on the formatter board. They are labeled I, II, III. They will either be solid or flashing. You need to determine what the sequence of the three LEDS are in order to decode the error. Here are the most common errors.

This LED sequence points to a faulty Hard Disk:

LED1: FLASHING
LED2: OFF
LED3: OFF

Faulty Hard Disk:

LED1: ON
LED2: FLASHING
LED3: OFF

Replace the Formatter:

LED1: ON
LED2: OFF
LED3: OFF

Replace Formatter and Main PCA board:

LED1: ON
LED2: ON
LED3: OFF

Replace Main PCA board:

LED1: ON
LED2: ON
LED3: FLASHING

---------------------------------------------------------------
08:04 error with a sub code reading:
LED1: FLASHING
LED2: ON
LED3: ON
. . . you must test the condition of the Engine to Interconnect cable first (outlined below).

 

If that fails . . .

Having worked with this printer for many years now, this error code generally ends up being an electrical gremlin somewhere in the system that cannot be identified. Hence, retiring the printer.

Designjetpartsfast.com now offers new Designjet printers, ink, and cartridges for immediately delivery. Models include T630, T650, T730, T830, T1600, T1700, T2600.

---------------------------------------------------------------

 Link to service manual pdf file:

 

Left Cover removal instructions begin on page 414.

Right Cover removal instructions begin on page 475.

--------------------------------------------------------------- 

Engine PCA Snoppy cable.

1. Remove the left cover.
2. Unplug the Snoppy Data cable on the Engine PCA.

3. Reboot the printer, and check printer behavior.

Front panel cable and interconnect PCA.

1. Remove the right cover.
2. Locate the interconnect PCA (4x4 board, facing front).
3. Unplug the cable in the upper right corner (labeled printer data).


4. Reboot the printer, and check printer behavior.

Does the printer boot up normally?
If yes, cable is shorting out the printer. Either use the printer as is, or else, replace the cable.

I have a replacement cable in stock, ready to ship. Please contact me for a quote.

If no, is the LED light on the interconnect PCA?
If no, the board may be dead; I would try replacing the PCA.

If the LED is 'on' PCA board is good.

 07.1:11 error indicates the cable is disconnected. If you get this, it confirms

the cable is good.

All parts are available elsewhere on the website.


Best Regards,
Tom
260.348.5653

Recent Articles

How to troubleshoot Designjet 08:11 error, 08:04 error Posted on October 07, 2019

Tags