Designjet Belt Sale $9.99 April 10 2015, 0 Comments
There are two easy ways to tell if your designjet 500 or designjet 800 printer needs its belt replaced. The first way is the most obvious, the carriage is jammed and will not move. Mostlikely, what has happened is the belt has become so frayed that it has split and is wrapped around the motor head on the right side. The other symptom of a faulty belt is a system error 86:10. This error generally indicates the belt is approaching the same state as the first case described.
The 86:10 error also may be due to a dirty encoder strip. The encoder strip is the metal strip running the length of the carriage axis and is how the carriage knows where it is located during the plot. Generally, taking a damp paper towel and wiping both sides of the encoder strip clean with your thumb and fore finger will clean it well enough to remedy it.
The best way to determine if your belt is defective is to open the front window and look below the belt the whole length of the printer. Specifically, run you finger along the axis below the belt and see if there are tiny black belt particles on the metal chassis. If there are, this is a good indication that your belt is defective and needs replaced.
To replace the belt, please watch the youtube videos provided in the product link.
Also, if you have any questions, please call me at 260.348.5653.
Part Numbering System
HP has many part numbers for the same part. They like to issue a new part number for a new lot being released for consumption. With carriage belts, the part numbering system is pretty simple.
Designjet 500, 510, and 800 24" belts are C7769-60182
Designjet 500, 510, and 800 42" belts are C7770-60014
HP service manual response to the system error 86:10
If this error code appeared but was NOT caused by a paper jam, then try the following:
> Too much friction in the Slider Rod. Enter the Printer Information utility (⇒ Page 4-26) and check the Scan-Axis usage. If the percentage is close to 100%, then lubricate the Slider Rod.
> The Carriage is bumping into the Service Station. If the carriage is stuck at the right hand side of the Printer and cannot be moved out to the center of the Print Platen it is because the Service Station cannot uncap the Printheads. In this case replace the Service Station/Aerosol Fan Assembly ⇒ Page 8-52.
> Perform the Carriage Movement test ⇒ Page 4-8.
System Error: 61:05
A related error is System Error: 61:05. A 61:05 is a formatter card with the sniffles before it becomes a cold (05:10) and needs replaced.
I was an HP Customer Engineer from 1995-2002. During this time, I serviced contract and warranty calls within the Northern Indiana area. When I left HP, I took my Designjet service experience and started my own business servicing out of contract plotters. Designjetpartsfast.com was launched in 2009. With over 19 years Designjet experience, I can help you resolve issues you are experiencing with your Designjet Printer.
Please call or email me with your Designjet questions. firstname.lastname@example.org 260.348.5653
Your one sources for complete Designjet repair satisfaction February 04 2014, 0 Comments
You can save thousands of dollars repairing your own Designjet plotter. I'm often asked, 'how long will my plotter last if I repair it myself?' The answer I've been using as a general rule is 4 to 5 years. With affordable replacement parts, fast delivery, detailed youtube instructions, and access to an experienced technician -- you have found your one sources for complete Designjet repair satisfaction.