HP Designjet T920 Service Station | CR357-67025
$ 320.00
Service Manual instructions to replace the Designjet T920, T1500, T2500 service station are included.
21.2:13 Failure moving service station
1. Use the power switch at the rear to turn off the printer, then disconnect the power cord. Check the
Primer Tubes.
Reconnect the power cord, then turn on the printer.
2. Ensure that the service station path is clear. Remove any visible obstacles (screws, plastic parts, etc.)
restricting the movement of the service station.
3. If the carriage has stopped over the service station, on the left of the printer, check that the cutter is not
activated. The cutter may be blocking the carriage over the service station, preventing the service
station from moving correctly. The cutter is on the right side of the carriage.
4. Perform the service station diagnostic test to troubleshoot the problem further.
Service engineer:
▲ Replace the service station. See Service Station with Drop Detector on page 309.
21:13 Problem with the Service Station motor
1. Ensure that the service station path is clear. Remove any visible obstacles (screws, plastic parts, etc.)
restricting the movement of the service station.
2. If the carriage has stopped over the service station, on the left of the printer, check that the cutter is not
activated. The cutter may be blocking the carriage over the service station, preventing the service
station from moving correctly. The cutter is on the right side of the carriage.
3. Perform the service station diagnostic test to troubleshoot the problem further.
Service engineer:
1. Use the power switch at the rear to turn off the printer, then disconnect the power cord.
Reconnect the power cord, then turn on the printer.
2. Replace the service station. See Service Station with Drop Detector on page 309.
